Image Button - Berger & Schroter LN-G3-B50 User Manual

You can observe the current magnification level on the bottom of the image display
once you start rotating the Super Controller. To decrease the image magnification,
rotate the Super Controller to the left (counter-clockwise) and image magnification
will decrease by 3x with each rotation. Factory default setting is 6x.
NOTE: During any image magnification adjustments, please avoid pressing onto
the Super Controller, as this may activate the device main menu.
POWER & IR BUTTON (5):
a) Initial short-press – turns the power ON.
b) When power is ON, single short press activates 1st power level
of IR illuminator. There are 3 IR power levels – each consecutive
short-press increases the power by one level. 4th short-press
turns the IR illuminator OFF.
c) When power is ON, long-press shuts the power OF.
CAMERA/LRF BUTTON (4)
a) Factory default recording mode setting is Video. Short-press
activates video recording. During video recording, short press
ends recording and video is automatically saved onto micro-SD
card.
b) When recording mode is switched to Photo, short press will
activate still image capture (system will make a short count down
and then capture the image).
c) When Laser Rangefinder is activated via main menu, long-press on Camera But-
ton activates rangefinder distance measurement. Each subsequent long-press acti-
vates Rangefinder distance measurement.
NOTE: short pressing camera button while rangefinder is activated will still
start video recording (if device is in Video mode) or will take a still image (if
device is in Photo mode).

IMAGE BUTTON (3)

a) Adjusts OLED displays brightness. Each short-press increa-
ses the display brightness by one level. There are 7 brightness le-
vels and the factory default setting is level-3. See page-33 for
more image brightness adjustment information.
30