Installing The Batteries - Berger & Schroter LN-G3-B50 User Manual

Gen-3 hd digital technology
Table of Contents

Advertisement

Available languages

Available languages

GLOSSARY:
1 – Objective Lens Focusing Ring
2 – IR Illuminator Focusing Wheel
3 – IMAGE Button
4 – CAMERA / LRF Button
5 – POWER / IR Button
6 – Ocular Focusing
7 – Rangefinder Lens

INSTALLING THE BATTERIES:

Your device operates on four 3V Lithium type batteries, known as CR123A type
commonly available in Electronics/Camera/Convenience stores. NOTE: it is pos-
sible to use rechargeable batteries (CR123R) but please make sure each bat-
tery peak voltage is equal to or less than 4.2V.
WARNING: if batteries supplied with the unit - they are not recharge-
able – do not charge or recharge these batteries!
To install the batteries, remove the battery cover, located on the bottom of the bi-
nocular by gently pressing onto the cover and at the same time sliding it in the di-
rection shown by arrow on the cover. Please note the
battery cover has an attached ribbon, which has two functi-
ons: one is to prevent the battery cover from being lost in
the field and second, to allow for easier batteries removal
by placing the ribbon under the batteries during installation.
Since there are 4 batteries that need to be installed, place
the ribbon under the bottom 2 batteries, then place it again
between the bottom and top batteries. Always follow pola-
rity when installing the batteries, placing negative (-) end
onto the metal springs. Replace the cover by sliding it back until you hear a clicking
sound indicating the cover has locked into place. Always make sure the cover is
locked securely prior to using the binocular in the field.
DAYLIGHT COLOR ENHANCING FILTER:
Your binocular is equipped with a unique daytime color enhancing filter, which pro-
vides vibrant and accurate colors rendition (digital image sensors are known to dis-
tort colors and provide an unnatural color image during daytime). The filter is
embedded into the objective lens cover (11-a) and we strongly recommend keeping
it on during daytime use in order to enjoy vibrant daytime color images. During
nighttime you will need to remove the lens cover, because the color filter will block
most of the built-in IR illuminator's light.
8 – Menu / Super Controller
9 – Power Indicator Light
10 – Folding Eyecups
11 – Lens Covers:
11-a) – Objective Lens Cover with
Rings built-in Daytime Color Filter
11-b) – Laser Rangefinder Lens Cover
24

Advertisement

Table of Contents
loading

This manual is also suitable for:

32155

Table of Contents