Optional) Setting Parameters Before Using Snmp - Huawei ETP48400-C9A2 User Manual

ETP48400-C9A2 Embedded Power
User Manual
Main Second-Level
Menu Menu
----End

6.7.3 (Optional) Setting Parameters Before Using SNMP

Prerequisites
Before setting SNMP parameters, obtain the information listed in
Table 6-9 Information obtained from the NMS
Information
SNMP version
SNMP Port Number
Read Community Name
Write Community Name
User Name
MD5/SHA Password
DES/AES Password
Trap Target Address
Trap Port
Trap community
Issue 05 (2020-04-07)
Third-Level
Menu
M/S Protocol
You can set SNMP parameters remotely or locally on the WebUI.
Copyright © Huawei Technologies Co., Ltd.
Fourth-Level Fifth-Level
Menu Menu
NOTE
This
parameter is
displayed
only when
Port Mode is
set to
Manual.
Baud Rate -
Comm. Address -
Description
SNMP version and port number used by the SMU and NMS.
The SNMP versions include SNMPv1, SNMPv2c, and
SNMPv3.
If you use SNMPv1 or SNMPv2c, enter the read community
name and write community name that comply with the NMS.
Otherwise, the SMU will not connect to the NMS.
The read community name must be different from the write
community name.
To enhance the security, you need a user name and password
for authentication if you use SNMPv3. After the
authentication succeeds, the SMU can communicate with the
NMS.
IP address and port number reported in the alarm trap.
If you use SNMPv1 or SNMPv2c, community name used for
reporting alarm trap packets.
6 Commissioning
Default Settings
Value
9600 9600
3 3
Table 6-9 from the NMS.
54