Troubleshooting - Honeywell Code Encryptor II Installation Manual

Troubleshooting

PROBLEM: I press Button #1 (largest, button) but nothing happens.
SOLUTION: 1) Did you teach the Code Encryptor II a VALID four-digit user code?
Note: The code you teach the Code Encryptor II must be a master
code or one of the current user codes.
2) Press button #2 (middle button), if you do NOT hear a "click" at
the receiver, GO TO PAGE 14 and learn that remote into the Code
Encryptor II.
PROBLEM: I press and hold button #3 (smallest button) and I do not get a panic.
SOLUTION: 1) Did you program the panel for keypad panic?
2) To program the Code Encryptor II for panic GO TO PAGE 13.
PROBLEM: I am using a DSC 1555 or a Power 832 and the alarm will not
ARM with the remote.
SOLUTION: Make sure you program the Alarm panel for "Quick Key Enable"
Section 015 #4 light "ON". Power down the alarm panel and power
it back up. Wait at least 60 seconds before you attempt to use the
remote control.
PROBLEM: I am using a Moose Z900/Z950/Z1100/Z1100E/ADT A910
and it is mis-identifying.
SOLUTION: Close zone one while plugging the CE II in.
PROBLEM: Unit does not seem to identify the panel I am using.
SOLUTION: Call technical 888-768-2846.
18