Honeywell Code Encryptor II Installation Manual page 18

TO DELETE ALL REMOTES
METHOD #1
To delete a lost or stolen remote from the Code Encryptor II, you must purge the
entire memory. This will delete all of the current remotes. You will then have to add
them back in one at a time. To purge the memory, disarm the panel. Enter 76278
from the keypad. The keypad on most panels will "beep" or the lights will turn off
momentarily to confirm delete. Follow the instructions on page 14 (To Add a New
Remote).
METHOD #2
To delete a lost or stolen remote from the Code Encryptor II, you must purge the
entire memory. This will delete all of the current remotes. You will then have to add
them back into memory. To purge, PRESS AND HOLD the program button, the
light will come ON for four seconds, then go OFF, and finally it will come ON again,
indicating that all the remotes in memory have been purged. Release the program
button and follow the instructions on page 14 (To Add a New Remote).
17