Honeywell Code Encryptor II Installation Manual page 15

Hide thumbs Also See for Code Encryptor II:

Table of Contents

To Add or Delete Remotes

TO ADD A NEW REMOTE

METHOD #1

To add a remote to your Code Encryptor II, disarm the panel and Enter 78738

from the keypad. The system will arm in the "STAY" mode. Press button #1 (largest

button) until the arm system disarms. It should take a total of four presses. THIS

FEATURE IS NOT AVAILABLE ON THE MOOSE ZX200/ZX400.

METHOD #2

To add a remote to your Code Encryptor II PRESS AND RELEASE the program

button on the receiver. The light on the receiver will come ON. Immediately PRESS

button 1 (largest button) on the new remote control THREE TIMES. The light on

the receiver should go OFF, indicating the remote has been learned. If the light on

the receiver stays ON, the remote has not been learned. Remove and replace the

harness, wait 15 seconds while auto recognition occurs and follow these instructions

again.

The Code Encryptor II can hold up to seven remotes.

Table of Contents

Need help?

Do you have a question about the Code Encryptor II and is the answer not in the manual?