Panic Mode - Honeywell Code Encryptor II Installation Manual

Hide thumbs Also See for Code Encryptor II:

Table of Contents

Panic Mode

Press and hold button 3 on the remote control for at least 3 seconds. This will cause

the panel to go into a panic mode. Press button 1 (largest button) to disarm the panel.

FOR DSC 1555/832 AND MOOSE ZX200/ZX400 YOU MUST ENTER

YOUR FOUR-DIGIT USER CODE TO CANCEL THE REMOTE PANIC. THE

REMOTE WILL NOT CANCEL A PANIC.

DEACTIVATING THE PANIC FEATURE:

In the event the user does not want to access a panic button through the remote

control, it can be de-activated from the Code Encryptor II's memory.

Step 1) Unplug the wire harness from the Code Encryptor II.

Step 2) Press and HOLD the program button.

Step 3) While HOLDING the program button, plug the Code Encryptor II harness

back in. The LED light located on the front will turn ON.

Step 4) Wait until the light turns "OFF".

Step 5) Once the light has turned "OFF" release the button

Table of Contents

Do you have a question about the Code Encryptor II and is the answer not in the manual?