Honeywell Code Encryptor II Installation Manual page 14

Hide thumbs Also See for Code Encryptor II:

Table of Contents

Panic Continued

ACTIVATING THE PANIC MODE

NOTE: This is the default setting of the Code Encryptor II.

If you have previously programmed remote panic "OFF" and would like to turn it

back "ON" follow the steps below. If this is a NEW installation Panic "ON" is the

DEFAULT setting for the Code Encryptor II.

Step 1) Unplug the wire harness from the Code Encryptor II.

Step 2) Press and HOLD the program button.

Step 3) While HOLDING the program button, plug the Code Encryptor II harness

back in. The LED light located on the front will turn ON.

Step 4) Immediately release the program button.

IF NECESSARY, PROGRAM THE ALARM PANEL FOR KEYPAD PANIC.

Table of Contents

Need help?

Do you have a question about the Code Encryptor II and is the answer not in the manual?