Table of Contents
Advertisement
Wireless Zones
XTLplus Series panels provide 99 wireless zones numbered 1 to 99. A default zone name, zone type, and area
assignment are provided for zones 1-48 and can be changed in
defaults are provided as a programming convenience to help reduce installation time.
Wireless Key Fobs and Outputs
XTLplus Series panels provide 8 wireless key fob or output addresses numbered 51 to 54 and 61 to 64. A default name
is provided as a programming convenience to help reduce installation time. The default names are described in the
programming sections of this guide and can be changed in
needed.
Keypads
Mounting Wireless Keypads
DMP Wireless keypads have removable covers that allow the base to be mounted on a wall, desk stand, or other flat
surface using the screw holes provided on each corner.
Associating Keypads
Associate up to seven DMP 9060 or 9063 Wireless LCD Keypads or 9862 Graphic Touchscreen Wireless Keypads to
the XTLplus panel, or one 7463 Network Keypad.
Flash LOAD Button
The XTLplus Series panel software can be updated via the panel's PROG programming header. To update the panel
with a new software version, complete the following steps at the protected premises:
Model 399 Cable
1.
Connect a DMP 399 Cable from the PROG header to the serial port of your PC operating Remote Link and
containing the XTLplus Series RU file.
2.
Start Remote Link and create or open the control panel account that matches the panel to be updated.
3.
Set the Connection Information Type to Direct with a baud rate of 38400 and choose the appropriate COM
port.
4.
Select Panel > Remote Update, then select the correct RU file for the panel.
5.
Press and hold the LOAD button, then press and release the RESET button.
Release the LOAD button and click <Update> in Remote Link.
6.
7.
After the software update is completed, remove the 399 cable and press the RESET button to resume normal
panel operation.
Model 401 USB Flash Module
1.
Press and hold the Reset (S1) button.
2.
Connect the USB flash drive containing the firmware file to the Model 401 and connect the assembly to the
panel's PROG header and press the button on the model 401 one time.
3.
With your finger still on the Reset button, press and hold the LOAD (S2) button then release the Reset button.
4.
Press and release the button on the 401. The green LED on the 401 should start a slow flash and run for 5
minutes. If the LED blinks rapidly, the update was not successful. Press and release the Reset (S1) button to
resume normal operation and start again at Step 1.
5.
After the green LED starts a slow flash, release the LOAD button.
6.
After the firmware version is updated the green LED will be steady.
7.
Press and hold the Reset button, remove the 401, then release the Reset button to resume normal operation.
On-Board Z-Wave Connection
The panel features an on-board Z-Wave controller that allows short range radio control of Z-Wave devices that you
or your installation company may provide such as: lighting control modules, thermostat controls, doors, and garage
doors. Z-Wave Setup allows you to program the system to control the Z-Wave devices from Smartphones using the
DMP Virtual Keypad App or from Virtualkeypad.com. The available setup options are: Add, List, Remove, Favorites,
Transfer, and Optimize.
XTLplus Series Installation and Programming Guide | Digital Monitoring Products
"Zone Information"
programming as needed. The
"Output Setup"
or
"Zone Information"
programming as
6
Advertisement
Table of Contents
