Removing The A-Arms; Installing The A-Arms - KTM 450 XC 2008 Repair Manual

61/ATV FRONT SECTION

Removing the A-arms

27.7
Info
The operations are the same on the left and right sides.

Installing the A-arms

27.8
Info
The operations are the same on the left and right sides.
–
Position brake line guide
Info
Note the holding lug of the brake line guide.
–
Mount brake disc guard
–
Mount the wheel/wheels. (
–
Check the toe. (
600445-11
–
Remove the wheel carrier. (
–
Remove screws
Info
When removing screws
600453-10
–
Remove screw
–
Remove screws
600454-10
–
Position lower A-arm
Specification
Screw, A-arm bottom
–
Position the shock absorber in the lower A-arm. Mount and tighten screw
Specification
Screw, front shock absorber
600454-11
–
Insert tool

Camber gauge (83019014000) (
–
Check the camber on both heim joints.
» If the marking
–
Remove the nuts on the heim joint.
–
Turn tool
with the top edge of the A-arm.
–
Remove tool
600127-10
and secure it with cable clamp

.

P. 60)
P. 172)
P. 175)
and take off upper A-arm

, make sure that bushings

and the shock absorber out of the guide.

and take off lower A-arm

. Mount and tighten screws

in the heim joint and clip onto the A-arm.
P. 211)
is not flush with the top edge of the A-arm:

with the heim joint in steps of 180° until the marking is in line

.

.

.

remain in place.

.

.

M10x70 45 Nm
(33.2 lbf ft)
M10 45 Nm
(33.2 lbf ft)
178
.
