Table of Contents
Advertisement
04/SHOCK ABSORBER, SWINGARM
–
Remove the needle of the special tool.
Filling adapter (83019050016)
–
Press in locking cap
Info
Do not scratch the inner surface.
200237-11
–
Remove the locking cap of the reservoir using the special tool.
Disassembly/assembly tool (83019050004)
200238-10
–
Reduce the dimension determined during assembly by the specified value and slide
the floating piston into the reservoir up to the reduced dimension using the special
tool.
Specification
7 mm
Disassembly/assembly tool (83019050005)
Info
200265-10
The floating piston must have the specified distance to the bottom stop.
The floating piston must be at precisely this position, as otherwise damage
may occur when the shock absorber moves.
–
Remove the special tool.
Disassembly/assembly tool (83019050005)
–
Remove adapter
–
Remove special tool
Adapter WP vacuum pump (83019050002) (
–
Mount and tighten the plug.
Specification
Plug for filling port
200272-10
–
Grease the O-ring of the locking cap of the reservoir.
Lubricant (T158)
–
Mount the locking cap of the reservoir using the special tool.
Disassembly/assembly tool (83019050004)
–
Mount the lock ring.
Info
Do not scratch the inner surface.
200238-10
–
Pull out the piston rod to the point where the seal ring holder is flush with the lock
ring.
–
Remove special tool.
Disassembly/assembly tool (83019050004)
of the reservoir and remove lock ring
from connector
of the vacuum pump.
.
M5
.
P. 213)
3 Nm (2.2 lbf ft)
30
Advertisement
Table of Contents
