Table of Contents
Advertisement
31/CARBURETOR
–
Position the float chamber and adjustment screw.
–
Mount screws
700067-10
–
Insert throttle slide
throttle slide arm
–
Position the needle clip on the jet needle.
Specification
Needle position (450 XC ATV)
Needle position (525 XC ATV)
Jet needle (OBEKR)
–
Insert the jet needle.
700037-12
–
Mount and tighten screw
Specification
Needle screw
–
Mount and tighten screw
Specification
Screw, throttle slide arm
600444-11
–
Position the throttle slide cover with the seal. Mount and tighten screws
Specification
Other screws, carburetor
–
Check/adjust the throttle slide opening. (
700035-12
–
Check/adjust the accelerator pump. (
–
Position seal ring
Info
The label on the membrane must be visible when mounted.
700060-10
–
Position seal ring
outward.
700059-10
but do not tighten them yet.
with throttle slide roller
and position them in the carburetor.
with the spring and washer.
M8
.
M4
M4
P. 149)
, membrane
and spring
in the accelerator pump cover with the rounded side facing
and the throttle slide plate into
2nd position from top
3rd position from top
3.5 Nm
(2.58 lbf ft)
2 Nm
Loctite
®
(1.5 lbf ft)
2 Nm (1.5 lbf ft)
P. 153)
.
155
243™
.
Advertisement
Table of Contents
