Table of Contents
Advertisement
REPLACE THE KERF PLATE INSERTS WHEN WORN. Excessive
●
tear-out increases the likelihood of injury from flying debris. When
setting the saw at a new angle, check that due to some mis-alignment,
the blade does not cut into the table insert, rear fence, or another part
of your saw.
●
CONNECT YOUR MITER SAW TO A DUST COLLECTING DEVICE
IF POSSIBLE. If not, use the dust bag that comes with the tool and
empty it regularly.
●
USE A SAWBLADE SUITED TO THE CUTTING JOB AND
MATERIAL TO BE CUT.
●
ALWAYS USE TABLE EXTENSIONS AND CLAMPS TO SUPPORT
THE MATERIAL WHEN SAWING LONG WORK PIECES.
●
DON'T START THE SAW WITH THE BLADE IN CONTACT WITH
ANY SURFACE. The saw head may bounce up or kick back violently
and cause injury.
●
IF MAKING A CUT USING ONE HAND TO HOLD THE SAW, ensure
the free hand is clear of the cutting area.
LASER SAFETY
To reduce the risk of injury:
1. Do not stare directly at the laser beam. Eye damage may occur if you
deliberately stare into the beam.
2. The laser light beam used in this system is Class II with maximum 1 mW
and 650 nm wavelengths. AVOID DIRECT EYE EXPOSURE.
3. The laser must be used and maintained in accordance with the
manufacturer's instructions:
● Never aim the beam at any person or an object other than the
workpiece.
● Do not project the laser beam into the eyes of others.
● Always ensure the laser beam is aimed at a workpiece without
reflective surfaces as the laser beam could be projected into your eyes
or the eyes of others.
Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
CALIFORNIA PROPOSITION 65
CALIFORNIA PROPOSITION 65
This product can expose you to chemicals including DEHP, which is
known to the State of California to cause cancer and birth defects or other
reproductive harm. For more information go to www.P65Warnings.ca.gov.
WEAR PROTECTIVE GEAR.
Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities contain chemicals known to cause cancer, birth
defects or other reproductive harm. Some examples of these chemicals are:
─Lead from lead-based paints
─Crystalline silica from bricks and cement and other masonry products
─Arsenic and chromium from chemically-treated lumber
Your risk from these exposures varies, depending on how often you do this
type of work. To reduce your exposure to these chemicals, work in a well
ventilated area, and work with approved safety equipment,
such as those dust masks that are specially designed to filter out
microscopic particles.
6
! WARNING !
Advertisement
Table of Contents
