Knuckle pin
MP grease
Coupling
Multi purpose
grease on
shaft
The illustration locates the lubrication points of the MHP15J.
Lubricants
Specific lubricants as recommended by Snorkel,
should be used in maintaining your unit. If in doubt
regarding the use of lubricants other than those
listed, contact Snorkel.
Pressure gun application
Service all fittings as indicated in the Maintenance
Schedule and lubrication illustration. Wipe away all
excess lubricant from exposed surfaces. Over
lubrication can collect dirt and foreign matter which
acts as an abrasive. Lubrication of accessory
equipment should be in accordance with the
manufacturer's recommendations.
Rotation bearing
Rotation bearing. Pressure gun lubricate bearing
at recommended interval using lubricant as
outlined in the maintenance schedule. Rotate while
lubricating. Lubrication fitting is located on the font
plate of the turntable.
Rotation gear teeth and pinion
Rotation gear teeth and pinion. Gear teeth and
gear box pinion should be lubricated with a multi
purpose grease.
MHP15J – 11995B
Maintenance Information
Hydraulic oil reservoir
Rotation bearing
(2 points)
Engines
Engine. Refer to the engine manufacturer's
instruction manual or consult your local engine
service representative if engine adjustments or
repairs are needed. The engine MUST be operated
in accordance with manufacturer's instructions and
serviced at recommended intervals.
Hydraulic oil reservoir
Hydraulic oil reservoir. The fluid level should be
kept between the low and full marks on the dipstick
and should be checked with all cylinders fully
retracted and the platform in stowed position.
It is absolutely necessary that only new, clean
hydraulic oil is added.
CAUTION
If it becomes necessary to add or use an oil
other than the recommended fluid, it is
important that it be compatible and
equivalent to the factory fill. Local oil
suppliers can generally furnish this
information.
If questions still remain, contact Snorkel for further
information.
and filter
RHS of Trailer
Rotation gear
teeth and
pinion
page 9