Lubricants; Pressure Gun Application; Rotation Bearing; Rotation Gear Teeth And Pinion - Snorkel MHP 13/35 Maintenance And Repair Parts Manual

Multi purpose
grease on
shaft
Hydraulic
oil reservoir
and return filter
This drawing locates the lubrication points of the MHP13/35.

Lubricants

Specific lubricants as recommended by Snorkel,
should be used in maintaining your unit. If in doubt
regarding the use of lubricants other than those
listed, contact Snorkel.

Pressure gun application

Service all fittings as indicated in the Maintenance
Schedule and lubrication drawing. Wipe away all
excess lubricant from exposed surfaces. Over
lubrication can collect dirt and foreign matter which
acts as an abrasive. Lubrication of accessory
equipment should be in accordance with the
manufacturer's recommendations.

Rotation bearing

Rotation bearing. Pressure gun lubricate bearing
at recommended interval using lubricant as
outlined in the maintenance schedule. Rotate while
lubricating. Lubrication fitting is located on the font
plate of the turntable.

Rotation gear teeth and pinion

Rotation gear teeth and pinion. Gear teeth and
gear box pinion should be lubricated with a multi
purpose grease.
MHP13/35 – 12431B
Maintenance Information
Rotation bearing
(2 points)

Engines

Engine. Refer to the engine manufacturer's
instruction manual or consult your local engine
service representative if engine adjustments or
repairs are needed. The engine MUST be operated
in accordance with manufacturer's instructions and
serviced at recommended intervals.

Hydraulic oil reservoir

Hydraulic oil reservoir. The fluid level should be
kept between the low and full marks on the sight
gauge indicator and should be checked with all
cylinders fully retracted and the platform in stowed
position.
The interior of the reservoir should be wiped out
and cleaned each time the hydraulic oil is changed.
It is absolutely necessary that only new, clean
hydraulic oil is added.
CAUTION
If it becomes necessary to add or use an oil
other than the recommended fluid, it is
important that it be compatible and
equivalent to the factory fill. Local oil
suppliers can generally furnish this
information.
Engine
Rotation gear
teeth and
pinion
page ix