Lubricants; Pressure Gun Application; Lubrication; King Pins (Item 1) - Snorkel S3370BE Parts & Service Manual

10
9
4
The drawing locates the lubrication points of the SR

Lubricants

Specific lubricants as recommended by Snorkel,
should be used in maintaining your unit. If in doubt
regarding the use of lubricants other than those
listed, contact Snorkel.

Pressure gun application

Service all fittings as indicated in the Maintenance
Schedule and lubrication drawing. Wipe away all
excess lubricant from exposed surfaces. Over
lubrication can collect dirt and foreign matter which
acts as an abrasive. Lubrication of accessory
equipment should be in accordance with the
manufacturer's recommendations.
NOTE
Any time the work platform is elevated to perform
maintenance work, properly position the safety bar
as outlined on the safety prop decal.
DANGER
DO NOT reach through scissors mechanism
u n l e s s t h e s a f e t y p r o p i s p r o p e r l y
positioned.
INJURY or DEATH could occur if the
platform is not supported by the safety prop
and should suddenly drop onto personnel
performing maintenance work under the
raised platform.
SR3370 & SR2770 – 13184B
5
11
7
Inside
Inside
Inside
compartment
engine
cabinet
cabinet
Maintenance Information
10
Includes center
pivot pins
8
6
Inside compartment

Lubrication

Refer to the above lubrication drawing for location
of the following item numbers.

King pins (Item 1)

King pin bearings are self lubricating. Check for
signs of damage and excessive wear as outlined in
the maintenance schedule.
DO NOT lubricate

Tie rods (Item 2)

Tie rod bearings are self lubricating. Check for
damage and excessive wear as outlined in the
maintenance schedule.
DO NOT lubricate

Steer cylinder end (Item 3)

Steer cylinder ends are self lubricating. Check for
damage and excessive wear as outlined in the
maintenance schedule.
DO NOT lubricate
Wheel bearings
Drive wheels (Item 4)
Wheel bearings used on drive wheels are sealed
bearings and do not require lubrication.
Rev D
1,2,3,4
page 11