Table of Contents
Advertisement
4
The error message (E30) will be displayed in Buffalo Dashboard.
5
Click Dismount Drive X (where "X" is the number of the failed drive).
6
When the message "Drive dismount finished. " is displayed, click OK.
The status LED will stop flashing and glow steadily.
7
If your TeraStation has a front cover, open it with the included key.
8
Push the unlock button of the failed hard drive and swing the lock mechanism out.
9
Pull out the hard drive cartridge and remove it from the TeraStation.
10
Insert the new drive into the empty slot. Slide the drive in with the locking mechanism open.
11
Swing the lock back down until it clicks into place.
12
Close the front cover with the included key. If the hard drive was replaced while the TeraStation was off, power
it on now.
35
Advertisement
Table of Contents
