LG TROMM F4999NTNH User Manual page 54

How to connect the Water Supply Hose
1. Make sure to connect the Cold valve (blue) to the cold water tap, and the Hot valve (orange) to the hot water tap.
2. If there is only one tap, connect to a cold water tap. In this case, there can be a pause of about 3 minutes to distinguish hot and cold water, and it
is normal.
3. After connecting the hose to the tap, turn on the tap and run it into a bowl to clean the foreign objects in the hose.
1 2
Fix the Upper
Connector to
the tap
 Push the upper connector  Turn the Middle Connec-
up until the rubber packing tor to the right and tighten
is in tight contact with the by screwing without cross
tap. Then tighten the 4 threading. Failure to do so
screws. may result in leakage.
 It will be easier to tighten
the screws if the big head
screw is to the wall side.
Upper
Connector
Upper
Connector
Push up and
insert until
the line
Middle
Connector
Rubber
Packing Big-head
screw
▣ Connecting to other types of taps
● Nipple type ① Disconnect the
nipple at the end.
Nipple
※ Follow the step 2, 3, and 4 of the 'How to connect water supply hose' for the rest of the connecting.
3
Connect Connect
the Middle the water
Connector supply hose
to the Upper to the middle
Connector. connector.
 Attach the water supply
hose to the middle con-
nector while pressing the
latch downward and the
latch plate.
 It is connected with a click
sound.
Middle
Connector
② Connect the upper
connector to the tap.
Upper
Connector
4
After
connecting a
hose to the
tap
 Turn on the tap and run
for a while to clean out
any foreign objects (dusts,
sands, saw dusts, etc.)
in the pipes. Check the
water temperature and
connect the hot water inlet
valve to the hot water
tap and cold
valve to
the cold tap.
Latch
Latch plate
● Screw type ① Remove the Guide
in the Upper
Connector.
Guide
5
Turn on the tap after
connecting the water
supply hose to the
tap
 Connect Cold (Blue) valve to the
cold water tap and Hot (Orange)
valve to the hot tap.
 Please check for a rubber seal
when connecting the hose since it
will leak without a seal.
※ If the water leaks, close the tap
and start again from step 1
Rubber seal
Hot water
inlet
Cold
water
inlet
② Connect the upper
connector to the tap.