LG TROMM F4999NTNH User Manual page 51

Troubleshooting
Error or Abnormal condition
※ If the next alarm condition is given, please check the following. It may not be a failure.
Alarm on the display unit Check
When steam comes out through the detergent
drawer or vent hole on the back side
Is the BOILING CARE course in progress?
Q
When the washer has no power
Is the power button pressed?
Q
Is the power cord plugged?
Q
Is the current leak breaker turned "OFF"?
Q
Is the washer connected to 110 V power?
Q
When the washer does not start
Is door closed and power button pressed?
Q
Is the water being supplied now?
Q
Is the water tap turned off?
Q
When the water flows down through the door
Is any thread or detergent in between the door and
Q
rubber seal?
When water keeps entering
It displays an alarm when the washer repeats water
Q
supplying and draining due to a faulty water supply
valve.
When the water height control is not working
It displays the left when the water height control is
Q
not working due to the malfunction of the water level
sensor.
When the drum is not moving
Did you add too much laundry?
Q
When the water is not heated
Action
If so, this is a normal for the steam to come out when
A
heating water for laundry.
Press the power button of the washer.
A
Plug the power cord tightly.
A
Reset the tripped breaker to "ON".
A
This product runs only at 220 V power.
A
Press the power button of the washer.
A
Wait until the water is filled to the set height.
A
Turn on the water tap.
A
Wipe the substances on the seal with clean clothing.
A
Unplug the power cord and call LG Electronics ser-
A
vice center or distributors.
Unplug the power cord and call LG Electronics ser-
A
vice center or distributors.
Unplug the power cord and call LG Electronics ser-
A
vice center or distributors.
Unplug the power cord and call LG Electronics ser-
A
vice center or distributors.