Panasonic AK-SHB800G Operating Manual page 47

[TALLY]
Item
[FRONT TALLY]
[BACK TALLY]
[BAR SETTING]
Item
[BAR SW]
[BAR SELECT]
[ROP SW]
Item
[ROP SW]
[TALLY IN]
Item
[TALLY IN]
[PANEL LED BRIGHT]
Item
[PANEL LED BRIGHT]
[7SEG BRIGHT]
Item
[7SEG BRIGHT]
Chapter 4 Menu Operations — Menu list (AK-SHU800)
Sets enable/disable and brightness of the front tally lamp.
[OFF], [LOW], [HIGH]
f Factory setting: [LOW]
Sets enable/disable and brightness of the back tally lamp.
[OFF], [LOW], [HIGH]
f Factory setting: [HIGH]
Enables/disables the color bar.
[OFF], [ON]
f Factory setting: [OFF]
Sets the type of the color bar.
[FULL], [SMPTE], [ARIB], [UHDTV CB], [UHDTV CB LIGHT]
f Factory setting: [FULL]
Sets the connection status (front/rear) of the <ROP> terminals.
[FRONT ONLY]: Enables only ROP connected to the front terminal.
[REAR ONLY]: Enables only ROP connected to the rear terminal.
[SWITCH SELECT]: Follows the selection with the <ROP SW> on the front panel.
f Factory setting: [REAR ONLY]
Selects the input signal of the TALLY signal.
[MAKE]: When TALLY IN H terminal and TALLY IN C terminal are OPEN, TALLY = OFF, when MAKE,
TALLY = ON
[V]: When voltage is applied to TALLY IN H terminal, TALLY = ON, when not applied, TALLY = OFF
f Factory setting: [MAKE]
Sets the brightness of indicators on the front panel.
[1]...[5]
f Factory setting: [3]
Sets the brightness of the 7 segment indicator on the front panel.
[1]...[15]
f Factory setting: [8]
– 47 –
Description of settings
Description of settings
Description of settings
Description of settings
Description of settings
Description of settings