Table of Contents
Advertisement
Shutter mode/speed setting
It is possible to limit the range of shutter speed selection or to use the synchro scan mode in advance with [MAIN MENU] → [SWITCH MODE] →
[SHUTTER SPEED] → [SHUTTER SPEED]/[SHUTTER MODE].
The selected shutter speed will be maintained even after the power of the unit is turned off.
@
NOTE
t Whichever mode the electronic shutter is used in, the higher the shutter speed, the lower the sensitivity of the camera becomes.
t When the aperture is in the automatic mode, it will increasingly open and the depth of focus will become shallower as the shutter speed is increased.
t Under lighting conditions using fluorescent lighting or other discharge tube, horizontal stripes might appear on screen. If this happens, this can be
improved by adjusting the shutter speed.
t A subject that quickly crosses the camera may appear distorted when shot. This is due to the method applied for reading the signals from the pickup
device (MOS sensor), and is not a malfunction.
Shutter related screen display
For details, refer to "On-screen displays of the monitor" (page 22).
Synchro scan mode setting
1
Set it to [MAIN MENU] → [SWITCH MODE] → [SHUTTER SPEED] → [SHUTTER MODE] → [SYNCHRO].
2
Set the shutter for the synchro scan in [MAIN MENU] → [SWITCH MODE] → [SHUTTER SPEED] → [SYNCHRO SCAN].
Chapter 3 Operation — Adjustment for shooting
– 27 –
Advertisement
Table of Contents
