Troubleshooting - Whirlpool AWD712S2 User Manual And Online Warranty

5. Troubleshooting

Below are suggested solutions before a technical service call.
If you experience the
following
Clothing is not being
dried properly, drying
times are too long or
the load is too hot.
Possible causes
Lint filter clogged with lint.
f----------------1-----------------1
Have you selected the Airing
cycle?
The load is too large and Separate the load so that it can
heavy to dry quickly.
The outdoor exhaust vent or
hood is clogged with lint,
obstructing air flow.
The exhaust vent is not the Check the exhaust vent to verify that
correct length.
The load consists of
multilayered items such
as pockets, collars etc
Solution
The lint filter must be cleaned before
every load.
Select the proper cycle for the type
of clothing that you want to dry. See
the "Cycles guide."
rotate freely.
Let the dryer run for 5-10 minutes.
Place your hand under the outdoor
ventilation hood to check for the
movement of air. If you do not feel
any, clean lint from the ventilation
system or replace the exhaust vent
with a heavy metal or flexible metal
one. Ensure that the exhaust vent is
not crushed or kinked. See the
"Installation instructions."
it is not too long nor has too many
turns. Ventilation with a long vent
will increase drying time. Be sure
that the exhaust vent is not crushed
or kinked. See the "Installation
instructions."
If any individual items are still damp
after the drying cycle has completed,
extend the drying process by setting
to a 30 minutes drying cycle.
II