Page 5
Remove the transport packaging ( fig. 1) and remove the dryer rack from the top packaging ( fig. 2) . Remove the tape on the front (fig. 3 and fig. 4), the Wall Mounting kit attached to the Drum with tape on the inside and the Panel film, before starting the dryer.
Page 6
The dryer can be mounted on a wall in the inverted position only by following these instructions. Invert Warning: Ensure that the screw and nut of the Wall Hanging Brackets are tightened during installation, if required. Regularly check all the screws and nuts and tighten, if required.
30 minute drying cycle, the last 10 minutes in cool down mode. 6. Set: Manually set drying cycle from 20 minutes to 240 minutes, the last 10 minutes in cool down mode. 7. Airing: 30 minute cool air cycle. No heat applied. TUMBLE DRYER AWD60A TumbleDryer_AWD60A-4.indd 16 5/8/08 4:26:06 PM...