CONTENTS QUICK REFERENCE GUIDE PROGRAMME CHART PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING INSTRUCTIONS FOR USE BOOKLET BEFORE USING THE DRYER / CONNECTIONS ELECTRICAL CONNECTION PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE DRYER...
BEFORE USING THE DRYER / CONNECTIONS 1. Removing the packaging and check • After unpacking, make sure that the dryer is undamaged. If in doubt, do not use the dryer. Contact After-Sales Service or your local retailer. • Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous.
3) Socket outlet / plug (valid for both countries) If the fitted plug is not suitable for your socket outlet, please contact Whirlpool Service for further instruction. Please do not attempt to change plug yourself. This procedure needs to be carried out by a qualified Whirlpool technician in compliance with the manufactures instructions and current standard safety regulations.
PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Packing The packing box may be fully recycled as confirmed by the recycling symbol. 2. Energy saving tips • Always dry a full load: depending on the type of laundry and the programme/drying time. • By preference use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy.
DESCRIPTION OF THE DRYER A. Work top B. Contact pin C. Door To open the door: pull the handle To close the door: push gently until closed. D. Filter Reminder - Maintenance and Cleaning Clean the lint filter at the end of every drying cycle: Open the door.
VENT CONNECTION Normally the hose and adaptor are not supplied; the accessory AMH 577 kit, available at your dealer or our After Sales Service, should be used. Installing the vent hose A. Place a towel or the packing material on the right-hand side next to the dryer.
DOOR REVERSIBILITY Door Reversibility A. Unplug the dryer. B. Open the door. C. Using a spanner, turn the contact pin on the inside of the door (top) through 90° and remove it. D. Remove the 2 door hinge screws, followed by the door. E.
TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE Troubleshooting Guide If a fault occurs, before contacting our After- Sales Service, make the following checks to try and remedy the problem: Drying takes too long / laundry is not dry enough: • Was the correct programme selected? •...