Clean The Lint Filter - Whirlpool AWD712S2 User Manual And Online Warranty

In the exhaust vent
Lint must be removed every 6 months, or sometimes more frequently, depending on the
frequency of usage.

4.4 Clean the lint filter

The lint filter is located inside the dryer door. A filter clogged with lint may increase drying time.
IMPORTANT:
• Do not operate the dryer with a loose, damage, clogged or missing lint filter. Doing so can
cause overheating and damage both the dryer and the clothing.
• If lint falls into the dryer when removing it from the filter, check the ventilation hood and
remove the lint. See "Ventilation System in page 7 ."
Cleaning when needed
Residue from laundry detergent and fabric softener may accumulate in the lint filter. This
accumulation may cause prolonged drying times for your clothing or cause the dryer to stop before
its load is completely dried.The filter is probably clogged if lint falls from it while inside the dryer.
Clean the lint filter with a nylon brush every 6 months or more frequently if it is being clogged
due to the accumulation of residues.
To wash it:
1. Remove lint from the filter by rolling it with your fingers.
2. Wet both sides of the lint filter with warm water.
3. Wet a nylon brush with warm water and liquid detergent. Scrub the lint filter with the brush
to remove the accumulated residues.
To clean:
1. Pull the filter straight up. Remove lint from the filter
by rolling it with your fingers. Do not rinse or wash the
filter to remove the lint.
2. Push the lint filter firmly until it locks back into place.
II