Table of Contents
Advertisement
Cleaning and maintenance preparation
1. Before cleaning or maintaining the range hood, be sure to
remove the power plug
.
2
Please wear rubber gloves when cleaning or maintaining, in
case the metal parts hurt people quickly.
.
3
When cleaning and maintenance, take off the parts and put
them gently to avoid deformation.
4. Please clean and maintain the range hood regularly according
to your usage frequency and surrounding environment.
Cleaning main body
.
1
After using the range hood everyday, should wipe advocate
airframe surface.
2.
To protect the coating on the surface of the body, please use
neutral detergent and soft cloth when wiping, do not use such
as toothpaste, washing brush and other bristle brush.
3.
Do not use gasoline, alcohol and other corrosive chemical
reagents or toothpaste, detergent, washing powder and other
detergent with grinding function to wipe the surface
Oil cup
Hold the oil cup with both hands horizontally and pull it outward
as shown in FIG. 4 to remove the oil cup. When the oil stored in
the oil cup reaches a certain amount, it shall be cleaned in time to
prevent overflow.
Clean oil guide plate
1. First, open the glass panel, and then hold the oil guide plate
with both hands to push upward, the oil guide plate can be
taken down;(figure 5)
2.
It will be better to use warm water anddetergent immersion for
a period of time to wash the oil guide plate , the oil guide plate
with a cloth to wipe clean, and then rinse again with water can
be;
3.
Every day after using the range hood , wipe the outer surface
of the oil guide plate lightly. It is recommended to clean the
inside of the oil guide plate once a week.
Clean the impeller
1. Special care should be taken when cleaning the impeller. Do
not collide or throw away the clamp on the blade, so as to
prevent the dynamic balance of the impeller from getting
worse and causing vibration and noise of the whole machine;
2. It is recommended to clean the impeller every three months.
Remove the LED lights
1. Open the glass panel, use the screwdriver to screw down the
fixed push rod screw, push the glass panel;(figure 6)
2. Open the glass panel to a certain angle, use a screwdriver or
knife to gently pry out the LED light, pull out the connector,
and then remove the LED light.(figure 7)
CLEANING AND MAINTENANCE
．
Oil cup
glass panel
Oil guide plate
6
Push rod screw
7
11
Advertisement
Table of Contents
