Table of Contents
Advertisement
Electric Shock Hazard
Read and follow the safety and warnings outlined in this user guide before
operating this appliance.
Never touch the power plug or electrical components, or manipulate the
power switch with wet hands.
Altering of the internal wiring is strictly prohibited, unless performed by
professional maintenance personnel.
When cleaning, never allow electrical components such as the motor, switch
and connector to get wet.
Failure to do so can result in death, electric shock, fire or injury to persons.
.
IMPORTANT SAFETY INSTRUCTIONS
WARNING! When using this appliance always exercise basic safety precautions
including the following:
Disconnect the power supply when cleaning or inspecting the product.
Do not damage or place heavy objects on the power cord.
There must be adequate ventilation of the room when the range hood is used at the same time
as appliances burning gas or other fuels. (A partial vacuum in the room could result in too high
a concentration of gas in the air).
Never expose the range hood to a burner or element that is turned on without a pot
covering it.
If the hood is installed above the gas appliance, the minimum distance between the support
surface of the cooking vessel on the cooktop and the lowest part of the range hood should be
at least 650mm. If the gas stove installation instructions specify a larger installation distance,
this should be considered.
Never use aluminium foil on the cooktop.
If using shared ducting, the air outlet must be well secured and sealed.
Exhaust gases must not be discharged into a hot flue being used to vent appliances burning
gas or other fuels.
Do not flambe directly under the rangehood.
Children and persons with reduced physical, sensory or mental capabilities shall not use the
range hood without supervision.
There is a fire risk if cleaning is not carried out in accordance with the instructions.
If installation is performed by a qualified person, the product should be tested to confirm
proper operation, and the correct use of the product explained to the use
If the power supply cord is damaged, it must only be replaced by your Haier trained and
supported service technician or qualified person.
Use a dedicated power outlet; the power cord must not be connected to an extension cord or
multi-socket power board. Secure grounding is required, and the power cord should be 000mm
in length.
Regulations regarding the discharge of air must be fulfilled.
This appliance is an
the air du t.
properly exhaust air ensure the duct is straight.
Do not clean the inside of the range hood. If you need to clean the inside, please contact your
Haier trained and supported service technician.
The appliance shall be
temperature -15°C ~ 40°C, relative humidity 9 % (at 25°C), altitude
Remove all packaging, including protective wrappings, before use.
CAUTION: Accessible parts may become hot when used with cooking appliances.
exhaust hood, air and smoke is di charged to the outside through
to work normally under the following environmental conditions:
pan
.
1000m.
Advertisement
Table of Contents
