Installation Instructions - Haier HH-S900C Installation Manual/User Manual

Hide thumbs

Table of Contents

Installation

WARNING!

This product is heavy and requires two persons for installation.

WARNING!

Failure to install the screws or fixing device in accordance with these instructions may result in electrical

hazards

Installation position

1. The room should be well ventilated without flammable, explosive or corrosive

materials or articles.

2. The wall used for mounting the rangehood should have sufficient strength and

a flat surface.

3. When drilling holes in the wall, do so away from water, electricity or gas lines to

prevent hazards such as electric shocks or gas leaks.

Tools to prepare

meter scale.

Accessory to prepare

Accessory should be prepared for installation of range hood, see packing list .

Installation steps

Mounting fixture

1. As shown in figure 1, find out the installation position of the fastening parts (host

and right.

too large, are forbidden to avoid loose plastic expansion tubes and lead to a fall;

3. Install the plastic expansion tube into the hole of the wall and fasten the fastening

parts on the wall with wood screws.

Fixed host

Hang the host on the host hook board on the wall. Please make sure that the host and

the host hook board are fastened and fit together without any shaking or loosening.

Fix the stop screw

Press the stop screw on the top surface of the housing to ensure that the stop screw

fits into the main machine without any looseness.As shown in figure 2.

Install the oil cup

Push the oil cup along the oil cup bayonet at the lower part of the fume collection cavity ．

Install check valve components

As shown in figure 3, tighten the check valve components and check valve gasket at

the outlet of the main engine and with eight M4*20 screws.

Connect the universal air duct

1. Insert the universal duct into the groove of the check valve seat and fasten it to the

2. Connect the other side of universal duct directly with the public flue or outside the

3. The length of the universal air duct shall not exceed 3000mm, or more than two

bends, so as not to affect the smoke exhaust .

Install the outer decorative cover

Take out the outer decorative cover , connect the outer decorative cover with the

decorative cover hook board and fix it together, and then the outer decorative cover

which has the hole to buckle the screw on the roof and gently push the outer

decorative cover backward, and then connect the outer decorative cover with the

hood and fix it.