Maintenance And Cleaning - Haier HH-OT53P Instruction Manual

work, motor does
not work
Oil leakage
Lights not working
Insufficient suction
The Cooker hood
inclines
NOTE:
Any electrical repairs to this appliance must conform to your local, state and
federal laws. Please contact the service centre if in any doubt before
undertaking any of the above. Always disconnect the unit from the power source when
opening the unit.

MAINTENANCE AND CLEANING

Caution:
• Before maintenance or cleaning is carried out, the cooker
hood should be disconnected from the mains power supply.
Ensure that the cooker hood is switched off at the wall socket
and the plug removed.
• External surfaces are susceptible to scratches and abrasions, so follow the cleaning
instructions to ensure the best possible result is achieved without damage.
GENERAL
Cleaning and maintenance should be carried out with the appliance cold especially
when cleaning. Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on
the surfaces.
STAINLESS STEEL
The stainless steel must be cleaned regularly (e.g.weekly) to ensure a long life
expectancy.Dry with a clean soft cloth. A specialized stainless steel cleaning fluid may
be used.
NOTE:
Ensure that wiping is done along with the grain of the stainless steel to prevent any
unsightly crisscross scratching patterns from appearing.
CONTROL PANEL SURFACE
Mains power cable is loose or
disconnected
One way valve and the outlet
are not tightly sealed
Leakage from the connection of
chimney and cover
Broken or faulty bulbs
The distance between the
cooker hood and the gas top is
too far
The fixing screw is not tight
enough
Refit mains power cable to
power outlet.
Switch power outlet on.
Take down the one way valve
and seal with sealant.
Take chimney down and seal.
Replace blubs as per this
instruction.
Refit the cooker hood to the
correct distance.
Tighten the hanging screw and
make it horizontal.
10