We recommend following 'Cleaning and maintenance' instructions for safety and optimal
performance of your range hood.
Preparation for cleaning and maintenance
● Be sure to unplug the power cord before commencing cleaning or servicing of the
range hood.
● Always wear rubber gloves during cleaning and maintenance to guard against injury
from sharp metal parts.
● Always handle removed parts carefully to avoid damaging them.
● Clean and service your range hood regularly, depending on the frequency of use.
Cleaning the main housing (daily)
● The outer surface of the range hood and filter should be wiped every day after use.
● To protect the stainless steel finish, use a neutral detergent and a soft cloth. Never use
hard brushes.
● Never wipe surfaces with corrosive chemicals such as gasoline or alcohol, or abrasive
cleaning agents.
Cleaning the oil collector (as necessary)
● When the oil collector is almost full,it should be removed promptly to avoid overflow.
● Pull the oil collector straight out to detach it from the filter.
● Empty the oil collector.
● The oil collector should be washed in
warm water with detergent (do not use
corrosive chemicals).
● To replace the oil collector, slide it into
the slot and ensure it is pushed all the way in.
Cleaning the filter(weekly)
● Remove oil collector (refer to
instructions above).
● Loosen the screw securing the filter.
● The filter should be washed in
warm water with detergent and left to soak.
Wipe clean with a rag and rinse with fresh water.
● To reassemble, put it back in place and tighten with screws.
● Slide oil collector into the slot and ensure it is pushed all the way in.
CLEANING AND MAINTENANCE
filter
11
oil collector
Fig5