Advertisement
We recommend following 'Cleaning and maintenance' instructions for safety and optimal
performance of your rangehood.
Preparation for cleaning and maintenance
Be sure to unplug the power cord before commencing cleaning or servicing of the
●
rangehood.
Always wear rubber gloves during cleaning and maintenance to guard against injury
●
from sharp metal parts.
Always handle removed parts carefully to avoid damaging them.
●
Clean and service your rangehood regularly, depending on the frequency of use.
●
Cleaning the main housing (daily)
The outer surface of the rangehood and filter should be wiped every day after use.
●
To protect the stainless steel finish, use a neutral detergent and a soft cloth. Never use
●
hard brushes.
Never wipe surfaces with corrosive chemicals such as gasoline or alcohol, or abrasive
●
cleaning agents.
Cleaning the oil receptacle (as necessary)
When the oil receptacle reaches the mark,
●
it should be removed promptly to avoid overflow.
Pull the oil receptacle straight out to detach
●
it from the Oil Cover.
Empty the oil receptacle.
●
The oil receptacle should be washed in warm water
●
with detergent (do not use corrosive chemicals).
To replace the oil receptacle slide it into the
●
slot on the
cover
the way in.
Cleaning the oil cover (weekly)
Remove oil receptacle (refer to
●
instructions above).
Loosen the screw securing the oil cover
●
The oil cover should be washed in
●
warm water with detergent and left
to soak. Wipe clean with a rag and
rinse with fresh water.
The inner part of the cover and the
●
cover
recess in the main housing
should be cleaned every week.
To reassemble; align the tabs and
●
angle the
cover
shown in Fig.5. Insert the screw and
tighten it using a screwdriver.
Slide oil receptacle into the slot on
●
the
cover
and ensure it is pushed all
the way in.
14
CLEANING AND MAINTENANCE
and ensure it is pushed all
into the recess as
Fig.5
Advertisement
