Attaching The Block To The Graphics Card; Checking For Contact - ekwb EK-Quantum Vector FTW3 RTX 3080/3090 User Manual

M2.5 x 4 AX1 SCREW
M2.5 PVC WASHER

CHECKING FOR CONTACT

If necessary, temporarily remove the water block to check for uniform
surface contact between the block and components. Pay special
attention to the VRM section of the graphics card. Check whether
the water block makes contact with the intended integrated circuit.
Then repeat Steps from the previous section to re-attach the block.
In case you fail to obtain good contact, please check
again or contact our support service at
https://www.ekwb.com/customer-support/.
STEP 2

ATTACHING THE BLOCK TO THE GRAPHICS CARD

Use seventeen (17) M2.5 X 4 AX1 screws and M2.5 PVC washers.
Tighten the screws evenly using the Phillips head screwdriver.
EK recommends you start tightening the screws around the GPU
core first and then continuing outward to prevent damaging the
GPU. Always use a plastic washer under each screw!
For this Step, you will need:
STEP 2
- 10 -
M2.5 x 4 AX1 M 2.5 PVC Washer
(17 pcs) (17 pcs)
Phillips Head
Screwdriver