Inserting The Graphics Card Into The Chassis; Fittings And Tubing - ekwb EK-Quantum Vector FTW3 RTX 3080/3090 User Manual

INSERTING THE GRAPHICS CARD INTO THE CHASSIS

Carefully lift your graphics card with the installed water block and
insert it into your PC's motherboard PCIexpress expansion slot.
Please keep in mind that your graphics card is heavier than before it
was equipped with the water block.
You need to be very careful when handling the
graphics card. Avoid all unnecessary manipulation
of the water block assembly that might damage your
card or water block.

FITTINGS AND TUBING

EK- PLUG
G1/4
EK-FITTING
TUBING
STEP 1
Screw-in two (2) G1/4 threaded male fittings. Attach the liquid
cooling tubes and connect the water block to the cooling loop.
EK recommends using EK fittings with all EK water blocks.
STEP 1
- 11 -
Do not forget to plug the remaining two openings with
enclosed EK-Plug G1/4 or its equivalent.
CAUTION: When using connectors other than EK fittings,
pay special attention to the length of the fittings' male G1/4"
thread – 5mm is the maximum G1/4" thread length allowed!