Preparing The Graphics Card; Removing The Stock Cooler; Cleaning The Pcb - ekwb EK-Quantum Vector FTW3 RTX 3080/3090 User Manual

Gpu water block
Hide thumbs Also See for EK-Quantum Vector FTW3 RTX 3080/3090:
Table of Contents

Advertisement

PREPARING THE GRAPHICS CARD

STEP 1

REMOVING THE STOCK COOLER

Place your graphics card on the flat surface and carefully remove the
stock cooler. Do not forget to unplug all the LED and fan connectors.
Pay attention to the following steps when installing the EK-Quantum
Vector FTW3 RTX 3080/3090 water block onto your graphics card.
STEP 2

CLEANING THE PCB

Wipe off the remains of the original thermal compound using a
nonabrasive cloth or Q-tip, as shown in the sample image, until the
components and circuit board are completely clean. EK recommends
the use of denatured alcohol for removing TIM leftovers. After that,
remove all remaining stock thermal pads from the PCB
STEP 2
- 7 -

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EK-Quantum Vector FTW3 RTX 3080/3090 and is the answer not in the manual?

Questions and answers

Table of Contents