Connecting The D-Rgb Led Strip; Replacing The Led Strip (Optional) - ekwb EK-Quantum Vector FTW3 RTX 3080/3090 User Manual
Gpu water block
Hide thumbs
Also See for EK-Quantum Vector FTW3 RTX 3080/3090:
- User manual (15 pages) ,
- User manual (13 pages)
Table of Contents
Advertisement
CONNECTING THE D-RGB LED STRIP
REPLACING THE LED STRIP (Optional)
D-RGB HEADER
RGB HEADER
STEP 1
M4/M2.5 x 13.5
(LONGER) STANDOFF
STEP 1
STEP 1
Plug the 4-pin D-RGB connector from the GPU water block to the
D-RGB Header on your motherboard or controller. The LED strip will
work only if the pin layout on the header is as follows: +5V, Data,
Empty, Ground.
Incorrect installation or installation to a wrong header can
damage to the LED strip or the header itself!
STEP 1
If you want to replace the D-RGB LED strip, you must remove the two
(2) standoffs shown in the picture using a 6mm wrench. Remove the
stickout and replace the LED strip.
Once you have replaced the LED strip, align the holes on
the stickout with holes on the top plate, and tighten the
standoffs evenly.
- 12 -
Advertisement
Table of Contents
Need help?
Do you have a question about the EK-Quantum Vector FTW3 RTX 3080/3090 and is the answer not in the manual?