Table of Contents
Advertisement
M2.5 x 4 AX1 SCREW
M2.5 x 6 AX1 SCREW
M2.5 NUT
STEP 2
ATTACHING THE BLOCK TO THE GRAPHICS CARD
PVC WASHER
Use thirteen (13) M2.5 X 4 AX1 screws and M2.5 PVC washers.
Tighten the screws evenly using the Phillips head screwdriver. EK
recommends you start tightening the screws around the GPU core
first and then continuing outward to prevent damage to the GPU.
Always use a plastic washer under each screw!
STEP 2
STEP 3
ATTACHING THE I/O BRACKET
After attaching the water block, use two (2) M2.5 X 6 AX1 screws
and one (1) M2.5 nut to secure the I/O bracket to the PCB.
STEP 3
- 12 -
Advertisement
Table of Contents
Need help?
Do you have a question about the EK-Quantum Vector XC3 RTX 3080 D-RGB and is the answer not in the manual?
Questions and answers