Hemstitching (3) (Drawn Work (2)) - Brother NV6000D Operation Manual

SEWING THE STITCHES
d
Press to create a mirror image of the
stitch.
e
Match beginning needle drop points on the
opposite edge of the open area to keep the
stitching symmetrical.

■ Hemstitching (3) (Drawn Work (2))

a
Pull out several threads from both sides of
the 4 mm (approx. 3/16 inch) area which
are not yet open.
* Pull out four threads, leave five threads, and then
pull out four threads. The width of five threads is
approximately 4 mm (approx. 3/16 inch) or less.
a Approx. 4 mm (approx. 3/16 inch) or less
b Four threads (pull out)
c Five threads (leave)
b
Select .
Memo
• For details on each stitch, refer to the
"STITCH SETTING CHART" at the end of
this manual.
120
c
Sew the decorative stitch in the center of
the five threads created above.
Memo
• A wing needle can be used for Hemstitching
(3).