Untangling Thread From Beneath The Bobbin Winder Seat - Brother NV6000D Operation Manual

LOWER THREADING
■ Untangling Thread from Beneath the
Bobbin Winder Seat
If the bobbin winding starts when the thread is not
passed through the pre-tension disk correctly, the
thread may become tangled beneath the bobbin
winder seat.
Wind off the thread according to the following
procedure.
a Thread
b Bobbin winder seat
• Do not remove the bobbin winder seat even if
the thread becomes tangled under the bobbin
winder seat. It may result in injuries.
a
If the thread becomes tangled under the
bobbin winder seat, press
stop the bobbin winding.
b
Cut the thread with scissors near the pre-
tension disk.
a Pre-tension disk
c
Push the bobbin winder switch to the right,
and then raise the bobbin at least 10 cm
(4 inches) from the shaft.
42
CAUTION
once to
d
Cut the thread near the bobbin and hold the
thread end with your left hand. Unwind the
thread counter clockwise near the bobbin
winder seat with your right hand as shown
below.
e
Wind the bobbin again.
Note
• Make sure that the thread passes through
the pre-tension disk correctly (page 38).