Brother NV6000D Operation Manual page 151

b
Attach presser foot "J" and sew straight
stitches up to the zipper opening. Change to
a basting stitch and sew to the top of the
fabric.
a Reverse stitches
b Wrong side of fabric
c Basting stitches
d End of zipper opening
c
Press the seam allowance open and align
the folded hem along the teeth of the
zipper, while maintaining 3 mm (approx.
1/8 inch) of sewing space.
a Zipper pull tab
b Wrong side of fabric
c Zipper teeth
d End of zipper opening
e 3 mm (approx. 1/8 inch)
d
Remove presser foot "J".
e
Align the right side of the pin in zipper foot
"I" with the presser foot holder, and attach
the presser foot.
a Right
b Left
c Needle drop position
CAUTION
• When using zipper foot "I", make sure the
straight stitch, middle needle position is
selected. Rotate the handwheel toward you
(counterclockwise) to make sure the needle
does not strike the presser foot. If another
stitch is selected, the needle will strike the
presser foot, causing the needle to break and
possibly causing injury.
f
Set the presser foot in the 3 mm (approx.
1/8 inch) margin.
g
Starting from the end of the zipper opening,
sew to a point about 50 mm (approx.
2 inches) from the edge of the fabric, then
stop the machine.
h
Pull down the zipper slider, then continue
sewing to the edge of the fabric.
a 50 mm (approx. 2 inches)
b 3 mm (approx. 1/8 inch)
CAUTION
• Make sure the needle does not strike the
zipper during sewing. If the needle strikes the
zipper, the needle may break, leading to
injury.
SEWING THE STITCHES
3
137