Brother NV6000D Operation Manual page 126

SEWING THE STITCHES
e
Unfold the edge of fabric, and position the
fabric with the wrong side facing up.
* Seen from the side
a Wrong side of fabric
b Basting line
c Bottom edge of fabric
f
Attach blind hem foot "R".
g
Select or
h
Remove the flat bed attachment to use the
free-arm.
i
Slide the item that you wish to sew onto the
free arm, make sure that the fabric feeds
correctly, and then start sewing.
a Free arm
112
.
j
Position the fabric with the edge of the
folded hem against the guide of the presser
foot, and then lower the presser foot lever.
a Wrong side of fabric
b Fold of hem
c Guide
k
Adjust the stitch width until the needle
slightly catches the fold of the hem.
a Needle drop point
When you change the needle drop point, raise the
needle, and then change the stitch width.
a Stitch width
Memo
• Blind hem stitches cannot be sewn if the left
needle drop point does not catch the fold. If
the needle catches too much of the fold, the
fabric cannot be unfolded and the seam
appearing on the right side of the fabric will
be very large, leaving an unattractive finish.
If you experience either of these cases,
follow the instructions below to solve the
problem.