Hemstitching (2) (Drawn Work (1)); Hemstitching (3) (Drawn Work (2)) - Brother DreamWeaver„ VQ3000 Operation Manual

SEWING THE STITCHES
c
Start sewing.
Example: Illustration of finished product

■ Hemstitching (2) (Drawn Work (1))

a
Pull out several threads from one area on a
piece of fabric to open the area.
* Pull out 5 or 6 threads to leave a 3 mm
(approx. 1/8 inch) area open.
Memo
• Loosely woven fabrics work best for this.
b
Select .
Memo
• For details on each stitch, refer to the
"STITCH SETTING CHART" on page S-67.
c
Attach presser foot "N". With the right side
of the fabric facing up, sew one edge of the
open area.
S-54
d
Press to create a mirror image of the
stitch.
e
Match beginning needle drop points on the
opposite edge of the open area to keep the
stitching symmetrical.

■ Hemstitching (3) (Drawn Work (2))

a
Pull out several threads from both sides of
the 4 mm (approx. 3/16 inch) area which
are not yet open.
* Pull out four threads, leave five threads, and then
pull out four threads. The width of five threads is
approximately 4 mm (approx. 3/16 inch) or less.
a Approx. 4 mm (approx. 3/16 inch) or less
b Four threads (pull out)
c Five threads (leave)
b
Select .
Memo
• For details on each stitch, refer to the
"STITCH SETTING CHART" on page S-67.