Crazy Quilting; Smocking Stitches - Brother NV6000D Operation Manual

SEWING THE STITCHES

Crazy Quilting

For a decorative look called "Crazy Quilting", the
following stitches can be sewn on top of a pressed
seam allowance.
a
Select a straight stitch and attach presser
foot "J".
b
With the right sides facing each other, sew
two pieces of fabric together, and then
press open the seam allowance.
a Straight stitch
b Seam margins
c 6.5 mm (approx. 1/4 inch)
d Wrong side
c
Select a stitch for top stitching.
d
Place the fabric right side up in the
machine, and center the presser foot over
the seam when sewing.
a Right side of fabric
116

Smocking Stitches

Use smocking stitches for decorative sewing on
clothes, etc.
a
Select a straight stitch and attach presser
foot "J".
b
Set the stitch length to 4.0 mm (approx.
3/16 inch) and loosen the upper thread
tension to approximately 2.0 (see "Setting
the Stitch Length" on page 67 and "Setting
the Thread Tension" on page 67).
c
Pull the bobbin and upper threads out by
50 mm (approx. 1-15/16 inches).
d
Sew the seams, leaving approximately
10 mm (approx. 3/8 inch) between the
seams, then trim excess thread, leaving
50 mm (approx. 1-15/16 inches).
a Approximately 10 mm (approx. 3/8 inch)
e
Pull the bobbin threads to obtain the
desired amount of gather, and then smooth
the gathers by ironing them.
f
Select or
Memo
• For details on each stitch, refer to the
"STITCH SETTING CHART" at the end of
this manual.
.