Table of Contents
Advertisement
Step 3. To hang the fan body in the
canopy, hold the fan body firmly and in-
sert the ball into the canopy opening.
Check that no wires were pinched. Ro-
tate the fan body until the slot in the
ball fits into the pin opposite the canopy
opening.
Note: Independent control of the
light fixture using a W-8 requires an
additional independent power wire
run from the wall switch to the fan.
See Page 7 for wiring.
Step 4. Attach the fan wires to the ceiling fixture outlet box
wiring by twisting the bare ends of the wires together and
then securing with a wire nut. Test that the connection is
secure by pulling on the wire nut. Connect in this order:
Step 5a. W-8 Wiring Connections - NO light fixture
• GREEN leads from mounting plate and fan to GROUND con-
ductor of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to RED wire from W-8 in ceil-
ing outlet box. Secure with wire nut.
• Cap BLUE D-1 Option wire with wire nut.
Step 5b. W-8 Wiring Connections - WITH light fixture
• GREEN leads from mounting plate and fan to GROUND con-
ductor of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to RED wire from W-8 in ceil-
ing outlet box. Secure with wire nut.
• BLUE wire from fan to YELLOW wire from W-8 in ceiling
outlet box. Secure with wire nut.
NOTE: See page 7 for additional wiring information.
Step 6. Tuck the wires into the canopy
with the wire nuts pointed upwards, so
that the WHITE and BLACK wires are on
opposite sides of the canopy and all wires
are clear of the canopy opening.
Step 7. Install canopy hatch with the
last canopy screw and lock washer. To
insert canopy screw, tilt the fan body
away from the hatch opening.
Step 8. Straighten the fan, then check
to ensure that there is no movement be-
tween the canopy and ceiling or Hang-Tru
ball and 12" extension tube.
HANGING THE FAN
CAPPED
BLUE
D1-OPTION
WIRE ON
3-SPEED ONLY
FOR INDEPENDENT
W-8 LIGHT
CONTROL
DO NOT attempt to attach the blades until after the fan body is
attached to the ceiling and Steps 5, 6, 7 and 8 are completed.
CANOPY ELECTRICAL CONNECTIONS
CANOPY HATCH INSTALLATION
CANOPY
HATCH
CANOPY
WASHER
M
S
ALIBU
BALL
SLOT
CAPPED
D1-OPTION WIRE
BLACK & RED
WIRES
2 WHITE WIRES
3 GREEN WIRES
WIRE NUT
BLUE & YELLOW
WIRES
BLACK & RED
WIRES
2 WHITE WIRES
3 GREEN WIRES
CANOPY
SCREW
®
TAR
PIN
W-8 CONNECTIONS
NO LIGHT FIXTURE
W-8 CONNECTIONS
WITH LIGHT FIXTURE
TILT THE
FAN TO
INSTALL
LAST
CANOPY
SCREW
5
Hide quick links:
Advertisement
Table of Contents
