Crossbar Mounting Bracket Installation; Canopy & Blade Hardware; Canopy Installation - Casablanca Malibu Star Owner's Manual

M

CROSSBAR MOUNTING BRACKET INSTALLATION

Proceed with installation as follows:
Step 1. Route the wires from the ceiling outlet box through
the crossbar mounting bracket center hole. Attach the bracket,
with ground wire and ridges down, to the ceiling fixture out-
let box with the mounting hardware included with the outlet
box.
Tighten the screws firmly by hand only, being careful not to
bend the bracket by over tightening.
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware provided with
the approved outlet box to install
the crossbar mounting bracket.
CANOPY
HATCH
CANOPY
Step 2. Attach the canopy to the crossbar mount-
ing bracket with three of the 8-32 x 2
canopy screws and canopy lock washers.
Tighten the screw firmly by hand only.
Note: On sloped ceilings, align the
canopy opening towards the top or
room peak.
4
S
ALIBU TAR
CANOPY & BLADE HARDWARE
CANOPY SCREW (4)
CANOPY
LOCK WASHER (4)

CANOPY INSTALLATION

1 long
/
4
®
CEILING FAN
APPROVED
OUTLET BOX
CEILING
WIRING
CROSSBAR
MOUNTING
BRACKET
FLAT
WASHER
OUTLET BOX
MOUNTING
HARDWARE
WIRE
NUT (4)
W-8
CONTROL
CROSSBAR MOUNTING
BRACKET INSTALLED
CANOPY
CANOPY LOCK
WASHERS
RIDGE
DOWN
ALLEN HEX
KEY
CANOPY
SCREWS
SIDE
GREEN
GROUND
WIRE