Casablanca Le Grande Owner's Manual page 10

Fan Control
To start the fan. Press the selected speed button to run the fan at the desired speed.
LO Low speed
MED Medium speed
HI High speed
To turn off the fan. Press the FAN OFF
Airflow Direction
To reverse the airflow press the REVERSE button. Reverse operates at any speed whether fan is
on or off. The fan returns to its set speed after reversing.
Light Control
Turn the light on or off independently from the fan by pressing the LIGHT button. Keep pressing
the button in excess of 0.7 seconds, it becomes a dimmer. The light varies from 'bright' to 'dim'
over approximately 8 seconds. This sequence will reverse the light when it reaches the brightest
or dimmest level if you continue to hold the LIGHT button. Release the button when the
desired level is reached.
Auto Resume
Quick (pressing less than 0.7 seconds) on/off operation of the LIGHT button maintains the
desired brightness level set previously.
VERSA•TOUCH
Remote Setting
Step 1. Remove battery.
Step 2. Check that the dip
switch in the remote is set
to '01110' - as shown.
Step 3. Check that the dip
switch in the fan is set the
same. (See section below
for fan dip switch location)
Note: All fans leave the factory set to '01110'.
VERSA•TOUCH
Note: If this is the second Versa•Touch fan installed in the
same area, one of the fans MUST have its channel changed
from '01110' or interference will occur. Make sure that the
dip switch settings in both the second remote and second
fan are set to the same numbers.
DIP SWITCH
SET TO '01110'
Checking Fan Setting
Step 1. Remove the three motor cover screws and lift the
motor cover off. Through the view hole on top of the motor,
locate the dip switch.
Step 2. Check that the dip switch in the fan and the remote
are set to '01110' . If this is a second fan, change the dip
switch settings, making sure that the fan and remote are set
to the same number.
Step 3. Replace the cover and screws.
9
VERSA•TOUCH OPERATION
button.
CONFIRMING CHANNEL DIP SWITCH SETTING - CONTROL
FIVE DIGIT DIP SWITCH
CONFIRMING CHANNEL DIP SWITCH SETTING - FAN
DIP SWITCH
SET TO '01001'
VIEW HOLE FOR
DIP SWITCH
SEND
SIGNAL
LED
9