Assigning Modulation Amount - Arturia VOCODER V User Manual

8.4.3. Assigning Modulation Amount

All Sources specify the Amount by which they modulate the Destinations, which can vary
from a subtle change to an obvious one. With the Envelope Follower and LFO, the Amount
parameter is below each Destination. In the Assign section, the Amount is the column to the
right.
With Amount = 1.00, the modulation source will control the full range of the Destination
parameter, in a positive way (e.g., turning up the Mod Wheel increases the Destination
parameter value). With Amount = -1.00, the modulation source will control the full range
of the Destination parameter, in a negative way (e.g., turning up the Mod Wheel decreases
the Destination parameter value). Amounts between these extremes trim the modulation
Source's effect. For example, if you want the Mod Wheel to turn up a parameter value to
only half of the available maximum, then set the Amount to 0.500.
58 Arturia - User Manual Vocoder V - Modulations Section