Patch Bay; How To Use The Virtual Patch Cables; Patch Bay Bypass - Arturia VOCODER V User Manual

7.6. Patch Bay

The Patch Bay allows for creative, innovative vocoder effects. In a standard vocoder, a
Modulator band controls the same frequency band for the Carrier. With the patch bay,
the analysis signals from any Modulator band (top row of jacks) can provide signals to
articulate the Carrier synthesizer's bands (bottom row of jacks).

7.6.1. How to Use the Virtual Patch Cables.

To use an analysis signal derived from the Modulator to articulate a band in the Carrier's
synthesizer (or vice-versa), click on a jack and drag the virtual patch cord to the desired
destination. An analysis jack can patch into a maximum of three synthesis destinations.
However, a synthesis band destination can receive only one analysis signal.
To disconnect a patch cord, right-click on a jack at either end of the patch cord. Or, click on
a plug that connects to a synthesis band, drag it anywhere other than another synthesis
band, and then release the mouse.

7.6.2. Patch Bay Bypass

The Patch Bay switch can bypass the current patch bay set up without having to remove
the patch cables. Switch Off to bypass, or On to use the current patch bay setup.
Arturia - User Manual Vocoder V - Vocoder Section 51