Cf_Dline Command; Cf_Pcstore Command; Cf_Pcmodefree Command - Canon LV-7290 Command Specifications

LV-7290 / LV-7295 / LV-7390/ LV-8225 Expand Serial Command Functional Specifications
8.5.7

CF_DLINE Command

Command "CF_DLINE_%1"[CR]
"0100"~"nnnn" --- Directly select Display Line setting value
%1
"UP" -------------- Current Display Line setting value + 1
"DN" -------------- Current Display Line setting value – 1
Set Display Line value of PC signal
Projector does not save the value set with this command so that it resets when
Details
projector turning into Standby status or ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.8

CF_PCSTORE Command

Command "CF_PCSTORE_%1"[CR]
"MODE1" ---- Store current PC Adjust status to Mode1
"MODE2" ---- Store current PC Adjust status to Mode2
"MODE3" ---- Store current PC Adjust status to Mode3
"MODE4" ---- Store current PC Adjust status to Mode4
"MODE5" ---- Store current PC Adjust status to Mode5
%1
"MODE6" ---- Store current PC Adjust status to Mode6
"MODE7" ---- Store current PC Adjust status to Mode7
"MODE8" ---- Store current PC Adjust status to Mode8
"MODE9" ---- Store current PC Adjust status to Mode9
"MODE10" --- Store current PC Adjust status to Mode10
Store current PC Adjust status (each parameter status such as Total dots) to
Mode1~Mode10. This command operates the same way as storing to
Details
Mode1-Mode10 in PC Adjust MENU.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.9

CF_PCMODEFREE Command

Command "CF_PCMODEFREE_%1"[CR]
"MODE1" ---- Set Mode1 to Free status
"MODE2" ---- Set Mode2 to Free status
"MODE3" ---- Set Mode3 to Free status
"MODE4" ---- Set Mode4 to Free status
"MODE5" ---- Set Mode5 to Free status
%1
"MODE6" ---- Set Mode6 to Free status
"MODE7" ---- Set Mode7 to Free status
"MODE8" ---- Set Mode8 to Free status
"MODE9" ---- Set Mode9 to Free status
"MODE10" --- Set Mode10 to Free status
Delete the registered data in Mode1-Mode10 and turns it to Free status.
This command operates the same as turning Mode1-Mode10 to Free in PC Adjust
Details
Menu.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"nnnn" shows maximum value, it is current Total Line value – Vertical
Position value
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
25