Cf_Wbal - Command; Cf_Coltemp Command; Cf_Progv Command - Canon LV-7290 Command Specifications

LV-7290 / LV-7295 / LV-7390/ LV-8225 Expand Serial Command Functional Specifications
8.4.8

CF_WBAL - Command

Command "CF_WBAL-%1_%2"[CR]
"R" --------------------- Red
%1 "G" --------------------- Green
"B" --------------------- Blue
"000~063" ----------- Directly select Color value specified by White Balance%1
%2 "UP" ------------------- Current Color value set by White Balance%1 + 1
"DN" ------------------- Current Color value set by White Balance%1 - 1
Set Color value set by White Balance%1 of user control
Projector does not save the value set with this command so that it resets when
Details projector turning into Standby status or ALL is OFF. (The value is held in Suspend
mode.)
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.4.9

CF_COLTEMP Command

Command "CF_COLTEMP_%1"[CR]
"000" ------ Xlow
"001" ------ Low
%1
"002" ------ Mid
"003" ------ High
Set Color Temperature. (Available only in the normal Power ON status)
The value set by this command will not be saved to the projector. Therefore, when
Details turning into Standby-mode or ALL is OFF, the value returns to original setting. (The
value is held in Suspend mode.)
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.4.10 CF_PROGV Command

Command "CF_PROGV_%1"[CR]
"FILM" -------- Select Progressive Mode FILM
"L1" ----------- Select Progressive Mode L1
"L2" ----------- Select Progressive Mode L2
%1
"OFF" --------- Cancel Progressive scan
"UP" --------------- The same operation as pressing Up key or Left key
"DN" ----------------The same operation as pressing Down key or Right key
Set / cancel Progressive scan
Projector does not save the value set with this command so that it resets when
Details projector turning into Standby status or ALL is OFF. (The value is held in Suspend
mode.)
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
20