Cf_Logo Command; Cf_Terminal Command - Canon LV-7290 Command Specifications

LV-7290 / LV-7295 / LV-7390/ LV-8225 Expand Serial Command Functional Specifications

8.10.9 CF_LOGO Command

Command "CF_LOGO_%1_%2"[CR]
%1 "0000"-"9999" ----------------- Set LOGO PIN CODE directly
"OFF" ---------------------------- Disable Logo function
"DFLT" --------------------------- Display Default Logo
%2 "USER" -------------------------- Display Captured Logo
"UP" ----------------------- The same operation as pressing Up key or Left key
"DN" ----------------------- The same operation as pressing Down key or Right key
Set / Cancel Logo
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF
This command is available in normal Power ON status.
%1--- Set LOGO PIN CODE
- When LOGO LOCK is in operation
PIN CODE is correct ------------------ Command is valid (Acceptable)
PIN CODE is incorrect ---------------- Command is invalid (Error Code "102")
Details PIN CODE is out of %1 range ------ Command is invalid (Error Code "? ")
-When LOGO LOCK is not in operation
PIN CODE is within %1 range ------ Command is valid
PIN CODE is out of %1 range ------ Command is invalid (Error Code "? ")
Note) Receiving correct LOGO PIN CODE while LOGO LOCK is in operation
enables to change LOGO setting, but it does not release LOGO LOCK. (LOGO
LOCK continues.)
Projector returns Error Code "101" by receiving USER in %2 when capture has
not operated.
Acceptable
Response
Unacceptable

8.10.10 CF_TERMINAL Command

Command "CF_TERMINAL_%1"[CR]
"COMPUTER" ----------------Set Input mode
%1
"MONITOR" ------------------- Set Monitor Out mode
Set Terminal setup. This command is available in normal Power ON status.
Details
Terminal means Computer 2 in this model.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
When Input is Computer 2, the projector returns "101" and the
command is not executed.
40